osckhar
God Member
Offline
www.3Dfx.es
Posts: 812
SPAIN
Gender: 
|
First Question:
Posted - 31/03/2003 : 09:17:32
--------------------------------------------------------------------------------
This great fix come from "Voodoo5 6000 Daddy" , Hank
Big thanks to him.
*******************************************************************
The following rework applies to PCB version 210-0391-001-A and 210-0391-001-A3.
3 boards have been modified and stability was improved on 3 motherboards, Tyan S1832D, Iwill KK266+R, Soyo KT333 Dragon Lite.
Two of the modified boards were margined for graphics clock speed operation above 166MHz. Boards ran stable at 186MHz and 191MHz.
Important!! The computer case was opened and well ventilated, 3.3V rail was measured at 3.32V and V5 6000 used stock cooling.
Rework:
1) Install 4.7K resistor – R540, R589, R717, R714
2) Change 22ohm Resistors to 0ohm resistors – R734, R743, R735, R745
This rework changes secondary PCI clock alignment and timing, to improve timing margin. Boards that used to fail within 30 seconds to 2 minutes completed over night runs on Quake 3 and (RWB2.3.2) GVT demo loop at 4xFSAA and 8xFSAA.
Second Question:
Dunno, perhaps with Clay Hudson. When he found 17 V6k and sold them on ebay.
Oscar.
|
Home
Pages: 1
two V56k question (Read 252 times)
